Offer Details

frequency splitter; works like an AB/Y splitter but already splits the signal into highpass and lowpass signal and feeds them into two separate signal chains / effects loops so you can put different effects on the high end and low end of your signal - especially helpful to put some crunchy overdrive or distortion on your bass while maintaining a clean low end rumble.this model is discontinued, you currently can't buy it new anywhere and listings on the internet are limited.Tyler is an active and variable two channel crossover/signal splitter, which divides your signal with HIGH PASS and LOW PASS paths. Both filters have a 12db/Oct. roll-off with a variable cut-off frequency from 20Hz to 3kHz. Each channel has its own foot-switchable buffered FX-Loop to process your lows (WOOD) or your highs (STEEL) with independent effects loops in parallel.The MIX knob controls the ratio of the Low Pass and High Pass signals. The range goes from 100% LP over to a 50/50 ratio until 100% HP when set fully clockwise. The mix control has a flat response, with equally chosen cut-off frequencies for the LP and HP to avoid notches or bumps. If required, the LEVEL control can boost your mixed signal up to 14dB. To avoid any phase-cancellation issues when external pedals are inserted, we also added a phase inverter and internal trim pots to better control the impedance for not only the main input, but also for each effects-loop. This is pretty handy when you want to insert your favourite fuzz pedal and get the tone just right.Some examples of use: Bass players want to retain their low end while using their favourite fuzz or dirt pedal. Insert your dirt box in the highpass FX-Loop and adjust the cut-off frequency of the High and Low Pass to your needs. Dial in your preferred ratio of those Low and High Pass signals, engage the STEEL footswitch and you will never turn off TYLER again! You can also insert different modulation pedals, for example insert a lush phaser for the lows and a nice shimmering delay for the highs and TYLER will make it sound like two different guitars are playing at once. Mix up your modulation pedals with any dirt pedals, for a very pronounced and punchy sound all coming from one amp.  As you can see, TYLER is like a Swiss army knife for your tone, being both a sonic tool and a supreme source of creativity – so take your axe and let the magic happen.Powered by an optional standard 9V DC (max.) PSU (negative center, 2.1mm, approx. 18mA current draw)(source: KMA machines)