An analog VCO module and an authentic reproduction of the original ARP 2600 circuitry

The VCO features 4 simultaneous waveforms including:
sine,
triangle,
saw
and pulse.

All of which offer a wide frequency control from 10Hz to 10kHz or 0.03Hz to 30Hz in LF mode.
The pulse width modulation can be simultaneously controlled manually and via an external CV input.
The module is also fitted with separate outputs for each waveform and 5 CV inputs for pitch control and pulse width modulation.

Mix It Up

The 2600-VCO is a feature rich module with four simultaneous waveforms: sine, triangle, saw and pulse which allow for an awe-inspiring palette of tonal possibilities. You can even control the oscillators frequency which ranges from 10 Hz to 10 kHz and from 0.03 Hz to 30 Hz when the 2600-VCO is switched to LF mode. The VCO can also be tuned to other instruments or VCOs with the Fine Tune knob. Adjust the pulse width range anywhere from 10% to 90% and you’ll be ready to rock whether you’re in a band or integrating the 2600-VCO into your monstrous setup!

Ins and Outs

The 2600-VCO comes with an array of FM and CV inputs. Each FM input comes with their own attenuator to control the level of modulation. A separate PWM input can be used if you want to control or modulate the Pulse waveform. The 2600-VCO even accepts control voltages from a keyboard or MIDI/CV converter which you can turn on or off with the Keyboard On/Off switch, which also switches the VCO to low frequency mode.

https://www.behringer.com/product.html?modelCode=P0E5N

• 140 mA +12V
• 5 mA -12V
• 0 mA 5V
• 42 mm Depth

This Module is currently available.