3D Printed panel for Korg Volca series

Credit goes to grappendorf on Thingiverse.

This is a 40HP Eurorack panel for mounting Korg Volca synthesizers directly into a Eurorack system.

Remove the Volca case from the PCB, desolder the battery and speaker cables and use 4 of the original screws to attach the Volca PCB to this Eurorack panel.

You need a 9V power supply to power the Volcas. You can either use a wall adapter or you can create a simple 12V to 9V linear regulator on a small perfboard to directly power the Volcas from your Eurorack power bus (In my case i also added a simple amplifier to boost the Volca audio output to the Eurorack audio level).

http://www.grappendorf.net/projects/eurorack/korg-volca-panels.html

http://www.grappendorf.net/projects/eurorack/korg-volca-panels.html

• Module is passive
• 30 mm Depth

Available as an assembled Module and as a DIY project.

This Module is currently available.