Analogue VU Meters Expander for Dynamics

The Dannysound VU Meters is designed to be used with 2 x Dynamics modules. The modules connect internally via 2x3 pin ribbon cables. The meters provide a visual representation of various signals within the Dynamics modules making settings easier.

Controls For Each Channel:

3 position toggle switch:
1. C/E OUT – Monitor compressor/expander output.
2. INPUT – Monitor Dynamics input level or external input if it’s used.
3. C/E AMT – Monitor Dynamics compression/expansion amount.

3 position toggle switch:
1. HI SENS – High sensitivity setting, best for monitoring the C/E OUT signal of percussive sounds and drums etc.
2. OFF – If you want to turn meters off. Note that this stops the needles moving but the backlights will stay on.
3. LO SENS – Low sensitivity setting, best for monitoring the C/E AMT signal or anything that overloads the HI SENS setting.

https://www.thonk.co.uk/shop/dannysound-vu-meters/

• 1 mA +12V
• 83 mA -12V
• 3 mA 5V
• 51 mm Depth

Module is available as a DIY project only.

This Module is currently available.