Delayed Envelope Generator

D-ENV
Delayed Gate/Trigger + Env Gen (AR/ADSR)
3 Env timing modes
CV to Delay time
Delay + Hold for Gate/Trigger Delays
Delayed Gate/Trigger can be routed internally at the push of a switch.

Note: All Specifications Subject to Change Without Notice


Size: 10hp

Depth: 35mm


Power requirements:
+12V = 61mA
-12V = 32mA

AR/ADSR type
Analog, Exponential


Envelope Timing (subject to tolerances of +/- 20%)

SHORT time mode:
Attack at minimum = 800 µs (0.8 ms)
Attack at maximum = 1.9 s
Release at mimimm = 1 ms
Release at maximum = 4.5 s

LONG time mode:
Attack at maximum = 30 s
Release at maximum = 60 s

EXTENDED LONG time mode: (jumper option selected on rear of PCB as header “P2”)
Attack at maximum = 64 s
Release at maximum = 180 s


Delay & Hold (Delay Pulse Processor)

DELAY Timing (for both Gate & Trigger)
Min Delay Time = 12 ms
Max Delay Time = 1050 ms

Delayed Gate Width (HOLD) Timing
Min Delayed Gate width = 12 ms
Max Delayed Gate width = 1050 ms

Delayed Trigger Width Timing
Delay Trigger Out (fixed) = 525 µs

CV to Delay (via D-TIME input jack)
Exponential response to linear CV in either “U” (+ Unipolar), or “B” (Bipolar) mode
Unipolar mode: 0v to +5V (jumper option selected on rear of PCB as header “P3 & P4”)
Bipolar mode: -5v to +5V (jumper option selected on rear of PCB as header “P3 & P4”)
Positive going CV increases delay-time


Note: All Specifications Subject to Change Without Notice - Vintage Synth Lab, LLC 2017

https://youtu.be/BQxd9bsrS-c

• 64 mA +12V
• 35 mA -12V
• 0 mA 5V

This Module is currently available.