Voltage Controlled Aux Send with EQ

Feed is a VCA with with an integrated EQ. It is being designed as some kind of voltage controlled aux send module.

If you insert an audio source into the jacks IN it will be directly routed to the THRU jack where you may use you original signal for further processing.

The signal is also directly routed to the VCA. Here you can control the volume or amplitude of the audio either manually or via control voltage using the CV jack.

Additionally you may change the frequencies of the singal using the TONE potentiometer. Turning counterclockwise will add low and cut high frequencies und turning the knob clockwise will cut low and boost high frequencies.

This works well with drums that will be send to an delay, reverb or any other effect when control voltage is being send to the CV jack.

● Voltag Controlled Amplifier
● Volume Control
● CV Attenuator
● Built in EQ
● Original signal is normalled to THRU out
● Wrong polarity protection
● Skiff friendly

The module consists of three boards:

● Front PCB Panel
● Main PCB with all components

More information on st-modular.com.

• 16 mA +12V
• 13 mA -12V
• 0 mA 5V
• 25 mm Depth

Module is available as a DIY project only.

This Module is an early prototype, a concept in development, or an AI mockup