Blank panel, dreadfully cheap and wannabe "acid"

ONE OF A KIND!!!
(Thank God)

A bad DIY blank panel, badly cut out of bad yellow plastic, with an Italian embarassing thing written on it:
Too poor for other modules - the other line is in English and you can directly read it instead of keeping on reading this useless info.
Thank you for checking in here, tho! I appreciate that. Good night.

DIY project

BOM
- cheap, light yellow plastic thing made like cardboard, semi-transparent. You could also use a green or blue piece, but it would sound less acid.
- BIC 1€ pen (better if blue)
- something that could write on plastic, that thing that's halfway between a marker and a pen.
- a small quantity of shame

Procedure
1. Put the plastic thing on your rack
2. Trace a 23 HP perimeter on that plastic thing with the pen
3. Cut it out with some childish scissors
4. See the screw holes there behind? Pop four holes out of the plastic thing with that same pen.
5. Find the marker/pen thing that you already lost, then draw and write some embarassing thing with it, something that would (not) make a girl smile.
6. Screw it in.

The kit comes pre-calibrated, but since you lost your time reading all this, you'd probably prefer to take out your friendly digital multimeter that costed you like a Macbeth dual VCO, and calibrate some useless parameter of your choice - with no results, but hey, at least you tried!

• 0 mA +12V
• 0 mA -12V
• 0 mA 5V
• 2 mm Depth

Available as an assembled Module and as a DIY project.

This Module is currently available.