Voltage controlled 4 Channel multiplexer module

The VC ROUTE is basically a voltage controlled 4 Channel multiplexer module. 1 common jack and 4 source/destination jacks for signal routing.
The ROUTE SELECT Potentiometer allows to manually select the channels. The ROUTE CV lets you CV-control the selection of the multiplexers channel. The four channels spread equal over a 0-10V Input voltage range.
The INHIBIT jack disconnects all channel switches. (if present voltage is greater 1V).

Tunable Parameters:
ROUTE SELECT potentiometer to manually set the route
I/O:
ROUTE CV in to select the route (0-10V)
INHIBIT in to disconnect all routes. (if present voltage is greater 1V)

http://seismic.industries/vc-route/

• 6 mA +12V
• 5 mA -12V
• 0 mA 5V
• 13 mm Depth

Available as an assembled Module and as a DIY project.

This Module is discontinued.