Dual channel oscilloscope, frequency meter and tuner

The Zeroscope 1U was created in partnership with VPME.DE and is an adaptation of the 3U Zeroscope module in Eurorack format.

Packed into this small 1U module is a full featured two channel digital oscilloscope, frequency meter and tuner all displayed on a bright OLED screen.

Three primary modes of operation

1. Scope
   Standard graphical display, with time displayed on the X-axis and voltage displayed on the Y-axis.
2. X-Y
   Alternate graphical display with CH 1 driving the X-axis and CH 2 driving the Y-axis.
3. Tune
   Alphanumerical tuning display, which you can configure to show either Hz values or note names.

Inputs & Outputs

CH 1 input:  The input is DC coupled and accepts signals between -10V and +10V.
CH 2 input:  This input, like CH 1, is DC coupled and accepts signals between -10V and +10V.
CH 1 output: The signal appearing at the CH 1 input jack is normalled to the CH 1 output jack, so signals pass unimpeded through the Zeroscope 1U. This allows you to monitor signals without needing to re-patch or use signal multipliers.
CH 2 output: As with CH 1, the signal appearing at the CH 2 input jack is normalled to the CH 2 output jack, so signals pass unimpeded through the Zeroscope 1U.

Controls

Scope: In Scope or X-Y modes, this screen displays both the CH 1 and CH 2 waveforms, while in Tune mode, it displays their frequency by either Hz or note name.
Encoder: This push-function encoder servers multiple functions — controlling the appearance of the scope, and enabling both the selection of parameters and the editing of their values.

Scope Range

• Timebase: 10us – 10s per division
• Voltage Range: 0.5V – 10V per division.

• 8 mA +12V
• 0 mA -12V
• 0 mA 5V
• 26 mm Depth

This Module is currently available.

Module is a 1U tile