An updated version of my THAT2180 VCA module.

Unlike some others, this module is built around the THAT2180 Blackmer cell IC - I find it easier to use, and less prone to self-destruction, than the V2164. There are a couple of different versions of the THAT2180 (A and B) but unless you're looking for insanely low levels of THD the C variant gives the best bang for the buck, so that's what I've included.

Unlike the previous incarnation of the module, this one now sits behind a 4HP panel and the layout has been slimmed down a bit too; there's a signal in (obviously) and a single CV input with an associated attenuator. Should you need to perform any additional calibration, there's a trimpot on the rear of the module.

These modules are built with Alpha 9mm potentiometers and Befaco micro knobs. The panel is fabricated from 1.6mm FR4 (PCB material)

https://www.yorkmodular.co.uk/collections/eurorack-modules/products/vcav2-that2180-based-voltage-controlled-amplifier-4hp

• ? mA +12V
• ? mA -12V
• ? mA 5V

This Module is currently available.