A dual set/reset latch with toggle inputs

Dual Latch is a utility module in a 2hp form factor. It is best described to someone unfamiliar with a latch as a trigger controlled gate - a trigger sent to a SET input (up arrow) sets the gate (!) output to its high state (on), while a trigger sent to the RESET input (down arrow) sets the gate low (off). The gates outputs swing from 0 to +7.5v volts and are buffered, and works well as an audio signal at this level. The gold up/down arrows are the TOGGLE inputs, for toggling the state of the gate - one trig will flip the state, another trig will flip it back. In this way it doubles as a divide by 2 or sub oscillator!. You get two of these ‘latches’ in a package.

The gates can be used to control anything in your Modular. This module was created to provide a way control the hold/freeze inputs on certain digital modules in a synchronized, rhythmic fashion. It is capable of completing this task as well as much more including frequency division and gate to pulse conversion. AND one of the gate outputs with another trigger signal sent to a voice for fills! It's a digital function generator that can be used alone or in conjunction with a wide range of other modules to add a new layer of control to your Eurorack system.

Typically triggers are sent to the inputs, but they are designed to accept any type of signal (they activate at 1.5 volts) and can handle a massive range of frequencies since the module has a CMOS heart.

Power is reverse polarity protected and current limited and uses a 10-pin Eurorack power ribbon.

tldr; it's a dual SR flip-flop with toggle inputs!

https://reverb.com/item/11492155-empirical-circuits-dual-latch

• ? mA +12V
• ? mA -12V
• 0 mA 5V
• 52 mm Depth

This Module is currently available.