Complex 3-part signal generator

The Spankulator is a WiFi-enabled multi-function Eurorack module. Its features include:

5 Waveform Types – Up, Down, Stretch, Toggle and Maytag
LFO with 3 waveforms – Sine, Ramp Up, Ramp Down
DVM – DC and AC modes
User Mode – For sending sequences of Waveforms and/or LFO bursts
All send modes have an output whose amplitude is adjustable via a dedicated control. Additionally, all send modes can send a single burst or can continuously repeat when Repeat is set to ON.

The Spankulator’s outputs are as follows:

Gate – 5 volt digital output. Pulses depend on mode of operation.
Toggle – 5 volt digital output. Changes state with each “burst”.
CV – +/- 5 volt analog output. Shape depends on mode of operation.
The Spankulator has these inputs:

Trigger – 5 volt digital input. Operation is triggered with a 0 to 5 volt transition on this input. This also serves as the External Clock when Ext Clk mode is enabled.
Sig In – +/- 5 volt analog signal input. Currently this input is only connected to the DVM.

The Spankulator has a WiFi-enabled Web Interface and a Terminal interface via USB. These two interfaces give the user two important capabilities.

The addition of a full-featured keyboard allows the user to type in parameters directly rather than adjust them digit-by-digit.
The user can run Macros that contain set-up or performance sequences.

https://www.greenfacelabs.com/spankulator/

• 100 mA +12V
• 25 mA -12V
• 0 mA 5V
• 35 mm Depth

Module is available as a DIY project only.

This Module is an early prototype, a concept in development, or an AI mockup